Westfield MKX10-53 » Red Power Team, Iowa
x
x

Westfield MKX10-53

Westfield MKX10-53 for sale at Red Power Team, Iowa

Double tap to zoom

Westfield MKX10-53 for sale at Red Power Team, Iowa

 

Features

Wear Edge Technology™

Westfield developed Wear Edge Technology™ to extend the life of the flighting. This provides an extra layer of steel welded to the edge on critical wear points. As a result, flighting lasts longer and needs to be replaced less often – saving time and money.

Powder Coat Paint
Westfield uses a durable powder coat paint for a strong, long lasting finish that looks good and protects against rust.

A-Frame Undercarriage
The MKX Series features an A-frame undercarriage to withstand bowing and maintain rigid alignment during heavy loads.

Low Profile Hopper
The low profile hopper features left and right hand flighting to pull grain toward the center of the hopper so it flows efficiently up into the tapered boot – maximizing capacity and minimizing unload time.

Optional Features

  • Low profile hopper
  • LED working lights
  • Transport lights
  • Right angle drive
  • Speed reducer-reverser kit
  • Reverser kit

Specs

MODEL MKX10-53
TUBE GAUGE 12 GA
TUBE CONNECTORS Heavy-Duty ³/16" (0.5cm) Angle Flange
MAIN FLIGHTING 9" (22.9cm) OD x 7 GA Stretched and Welded with Wear Edge Technology™ at Critical Points
WEAR EDGE TECHNOLOGY
(REINFORCED FLIGHT)"
¼" (0.6cm) plus 10 GA Ribbon Weld = 5 /16" (0.8cm) Wear Edge Technology™ on Critical Grain Transfer Points
FLIGHTING SHAFT High Strength 2" (5.1cm) OD x 11 GA Tubing Square Flight Connection
UPPER BEARING 1 ¼" (3.2cm) Pillow Block Greaseable Ball Bearing
LOWER BEARING 1 ½" (3.8cm) Pillow Block Greaseable Ball Bearing
TUBE TRUSSING 5 /16" (0.8cm) Aircraft Type Galvanized Steel Cable
HYDRAULIC LIFT Single 4" (10.2cm) Cylinder with 5 /16" (0.8cm) Aircraft Cable
UNDERCARRIAGE 3" (7.6cm) x 11 GA A-frame
AXLE 2 ½" (6.03cm) x 2 ½" (6.3cm) x 1/8" (0.3cm) Wall Square Tubing
HUB 4-Bolt Agricultural Type
TIRES 15" (38.1cm)
PTO SHAFT 14E Constant Velocity with 5 /16" (8mm) Shear Bolt
PARKING JACK 2000 lbs. (907.2 kg) Side Wind
SPROCKET & CHAIN Hardened Tooth Sprocket with #60 Chain
LOW PROFILE HOPPER DIMENSIONS 63" Length (160cm) x 40" Width (101.6cm) x 10.5" Height (26.7cm)
PSI REQUIRED TO RAISE AUGER 1000 PSI (68.9 bar)
HP REQUIRED (WITH DRY WHEAT) 50 HP (37.3 kW)
WHEEL TREAD 106" (2.7m)
TRANSPORT HEIGHT 12' 6" (3.8m)